National Stock Number
2520-01-388-5831
National Stock Number (NSN) 2520-01-388-5831, or NIIN 013885831, (yoke,universal joint,vehicular) was assigned April 4, 1994 in the Federal Logistics Information System (FLIS). NIIN 013885831 was cancelled on December 2, 2015, with a cancelled status of "Item is Cancelled WITHOUT Replacement." There is no known replacement specified for this stock number. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is somewhat common among different platforms, belonging to 2 different weapons systems.
There has been very little demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Nov 15, 2020, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 52120. [A COMPONENT OF A UNIVERSAL JOINT DESIGNED FOR VEHICULAR APPLICATIONS. CONSISTS OF A FORK-LIKE DEVICE TO ACCOMMODATE THE SPIDER AND BEARINGS OF A UNIVERSAL JOINT BY VARIOUS ATTACHING METHODS. THE OPPOSITE END MUST HAVE EITHER A FLANGE, HUB, OR SPLINED STUB SHAFT WHICH IS DESIGNED TO BE ATTACHED TO A DRIVING OR DRIVEN MEMBER. FOR ITEMS WITH A SHAFT, THE LENGTH OF THE PLAIN PORTION MUST NOT EXCEED THE LENGTH OF THE SPLINES.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 2520013885831 does not contain precious metals.
This information was last updated on Jun 01, 2024.