National Stock Number
3040-01-192-1635
National Stock Number (NSN) 3040-01-192-1635, or NIIN 011921635, (shaft,shouldered) was assigned October 17, 1984 in the Federal Logistics Information System (FLIS). NIIN 011921635 was cancelled on April 2, 2014, with a cancelled status of "Item is Cancelled WITHOUT Replacement." There is no known replacement specified for this stock number. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 3 suppliers. Today, 2 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, 2 suppliers are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is unique to one weapons system.
There has been very little demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Dec 05, 2020, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22914. [A SHAFT HAVING TWO OR MORE DIFFERENT DIAMETERS (GREATER THAN 0.031 INCHES (0.79 MILLIMETER)) ALONG ITS LENGTH. IT MUST HAVE ONE OR MORE OF THE FOLLOWING CONDITIONS: A SPECIFIED SURFACE FINISH DESIGNATION IN THE RANGE 1 TO 125 MICROINCHES (0.025 TO 3.2 MICROMETERS) ARITHMETICAL AVERAGE (AA), MACHINED PERIPHERAL FLAT(S), CIRCULAR GROOVE(S), KEYWAY(S), SPLINES, THREADS, OR HOLES. THE ENDS AND/OR SHOULDERS MAY BE MACHINED TO ACCOMMODATE BEARINGS, COUPLINGS, AND THE LIKE. IT IS NOT DESIGNED FOR USE IN ALIGNING BY FITTING INTO CORRESPONDING HOLES OF ANOTHER ITEM. FOR ITEMS USED TO SUPPORT ROTATING MEMBERS SEE AXLE(1), SHOULDERED. FOR ITEMS NOT HAVING ANY OF THE ABOVE CONDITIONS SEE PIN, SHOULDER, HEADLESS. EXCLUDES:SHAFT(1), STRAIGHT; AND AXLE(1), STRAIGHT.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 3040011921635 does not contain precious metals.
This information was last updated on Jun 01, 2025.