National Stock Number
3040-01-307-2918
National Stock Number (NSN) 3040-01-307-2918, or NIIN 013072918, (axle,shouldered) was assigned September 8, 1989 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, there are no suppliers listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts. ISO Group has several sources of supply for this NSN.
This part number has not been procured by the US Government in over 5 years.
This NSN is somewhat common among different platforms, belonging to 3 different weapons systems.
There has been very little demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Jul 02, 2005, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The Government physically does not have in its possession sufficient, accurate, or legible data to purchase this part from other than current source(s). (NOTE: This code is applicable only to parts under immediate buy requirements and only as long as the deficiency is under review for resolution and appropriate recoding.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 40525. [AN AXLE HAVING TWO OR MORE DIFFERENT DIAMETERS GREATER THAN 0.031 INCHES (0.79 MILLIMETERS) ALONG ITS LENGTH. IT MUST HAVE ONE OR MORE OF THE FOLLOWING CONDITIONS: A) A SPECIFIED SURFACE FINISH DESIGNATION IN THE RANGE OF 1 TO 125 MICROINCHES (0.025 TO 3.2 MICROMETERS), B) PERIPHERAL FLAT(S), C) CIRCULAR GROOVE(S), D) KEYWAY(S), E) SPLINES, F) THREADS, OR G) HOLES. THE ENDS AND/OR SHOULDERS MAY BE MACHINED TO ACCOMMODATE BEARINGS, COUPLINGS, AND THE LIKE. IT IS NOT DESIGNED FOR USE IN ALIGNING BY FITTING INTO CORRESPONDING HOLES OF ANOTHER ITEM. FOR ITEMS USED TO TRANSMIT MOTION, SEE SHAFT (1) SHOULDER. FOR ITEMS NOT HAVING ANY OF THE ABOVE CONDITIONS, SEE PIN, SHOULDER, HEADLESS. EXCLUDES:BOTH SHAFT (1), STRAIGHT AND AXLE (1), STRAIGHT.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 3040013072918 does not contain precious metals.
This information was last updated on Jul 01, 2025.