National Stock Number (NSN) 3040-01-429-5658, or NIIN 014295658, (shaft,shouldered) was assigned April 13, 1996 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, 2 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, 2 suppliers are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is somewhat common among different platforms, belonging to 3 different weapons systems.
There has been very little demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on May 21, 2020, this NSN's acquisition method was noted as: Acquire only from the prime contractor although the engineering data identifies the Commercial and Government Entity Code (CAGE) and part number of a source other than the prime contractor. The design of this part is unstable. Engineering, manufacturing, or performance characteristics indicate that the required design objectives have not been achieved. Major changes are contemplated because the part has a low process yield or has demonstrated marginal performance during tests or service use. These changes will render the present part obsolete and unusable in its present configuration. Limited acquisition from the present source is anticipated pending configuration changes. Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22914. [A SHAFT HAVING TWO OR MORE DIFFERENT DIAMETERS (GREATER THAN 0.031 INCHES (0.79 MILLIMETER)) ALONG ITS LENGTH. IT MUST HAVE ONE OR MORE OF THE FOLLOWING CONDITIONS: A SPECIFIED SURFACE FINISH DESIGNATION IN THE RANGE 1 TO 125 MICROINCHES (0.025 TO 3.2 MICROMETERS) ARITHMETICAL AVERAGE (AA), MACHINED PERIPHERAL FLAT(S), CIRCULAR GROOVE(S), KEYWAY(S), SPLINES, THREADS, OR HOLES. THE ENDS AND/OR SHOULDERS MAY BE MACHINED TO ACCOMMODATE BEARINGS, COUPLINGS, AND THE LIKE. IT IS NOT DESIGNED FOR USE IN ALIGNING BY FITTING INTO CORRESPONDING HOLES OF ANOTHER ITEM. FOR ITEMS USED TO SUPPORT ROTATING MEMBERS SEE AXLE(1), SHOULDERED. FOR ITEMS NOT HAVING ANY OF THE ABOVE CONDITIONS SEE PIN, SHOULDER, HEADLESS. EXCLUDES:SHAFT(1), STRAIGHT; AND AXLE(1), STRAIGHT.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 3040014295658 does not contain precious metals.
This NSN is associated to Schedule B 8483105000: transmission shafts and cranks, except camshafts and crankshafts. The Schedule B End Use is listed as industrial machines, other. NAICS classification category 333613: mechanical power transmission equipment manufacturing.
This information was last updated on Sep 01, 2024.