National Stock Number
3040-01-537-0176
National Stock Number (NSN) 3040-01-537-0176, or NIIN 015370176, (shaft,straight) was assigned January 24, 2006 in the Federal Logistics Information System (FLIS). NIIN 015370176 was cancelled on December 18, 2018, with a cancelled status of "Item is Cancelled - Inactive." There is no known replacement specified for this stock number. This NSN does not replace any other NSNs.
There are 3 manufacturer part numbers associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Jan 25, 2020, this NSN's acquisition method was noted as: Acquire only from the prime contractor although the engineering data identifies the Commercial and Government Entity Code (CAGE) and part number of a source other than the prime contractor. The design of this part is unstable. Engineering, manufacturing, or performance characteristics indicate that the required design objectives have not been achieved. Major changes are contemplated because the part has a low process yield or has demonstrated marginal performance during tests or service use. These changes will render the present part obsolete and unusable in its present configuration. Limited acquisition from the present source is anticipated pending configuration changes. Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22109. [A STRAIGHT SHAFT HAVING TWO OR MORE OF THE FOLLOWING CONDITIONS: A SPECIFIED SURFACE FINISH DESIGNATION IN THE RANGE OF 1 TO 125 MICROINCHES (O.O25 TO 3.2 MICROMETERS), ARITHMETICAL AVERAGE (AA), MACHINED PERIPHERAL FLAT(S), CIRCULAR GROOVE (S), KEYWAY(S), SPLINES, THREADS, OR HOLES. IT IS NOT DESIGNED FOR USE IN ALIGNING BY FITTING INTO CORRESPONDING HOLES OF ANOTHER ITEM. IT MAY BE DRILLED FOR LUBRICATING HOLES. FOR ITEMS HAVING AN INTEGRAL GEAR(S) OR WORM(S), SEE GEARSHAFT (AS MODIFIED). FOR ITEMS DESIGNED TO SUPPORT ROTATING MEMBERS SEE AXLE(1), STRAIGHT. FOR ITEMS NOT HAVING THE ABOVE CONDITIONS SEE PIN, STRAIGHT, HEADLESS. FOR ITEMS HAVING MACHINED ENDS WHICH CONSTITUTE STEPS SEE SHAFT(1), SHOULDERED; AXLE(1), SHOULDERED; AND BOLT, FLUID PASSAGE.]. The item is a non-aviation Critical Safety Item (CSI) whose failure will result in serious damage to equipment or serious injury or death to personnel. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 3040015370176 does not contain precious metals.
This information was last updated on May 01, 2025.