National Stock Number
5310-01-020-5117
National Stock Number (NSN) 5310-01-020-5117, or NIIN 010205117, (washer,flat) was assigned April 30, 1976 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment.NIIN 010205117 was cancelled on February 2, 2014, with a cancelled status of "Item is Cancelled WITHOUT Replacement." There is no known replacement specified for this stock number. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. 2 of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Apr 17, 2014, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The Government physically does not have in its possession sufficient, accurate, or legible data to purchase this part from other than current source(s). (NOTE: This code is applicable only to parts under immediate buy requirements and only as long as the deficiency is under review for resolution and appropriate recoding.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 13393. [A WASHER HAVING A CENTRALLY LOCATED HOLE WITH A SOLID OR LAMINATED CROSS-SECTION AND TWO FLAT PARALLEL BEARING SURFACES. THE HOLE MUST BE 75 PERCENT OR LESS THAN THE LARGEST DIMENSION AND THE BEARING SURFACE FINISH IS GREATER THAN 32 MICROINCH (0.8 MICROMETER). THE THICKNESS CANNOT EXCEED 25 PERCENT OF THE LARGEST OUTSIDE DIMENSION. WHEN THE LARGEST OUTSIDE DIMENSION IS LESS THAN 1/4 INCH OR 6MM, THE THICKNESS MUST BE 0.006 INCHES (0.15MM) OR GREATER AND FOR ITEMS 1/4 INCH (6MM) OR LARGER, THE THICKNESS MUST BE 0.016 INCHES (0.4MM) OR GREATER. THE MAXIMUM TOLERANCE IS APPLIED TO DIMENSIONS AND USED AS A DETERMINING FACTOR. ITEMS WITH SEPARABLE LAMINATION USE SHIM. FOR ITEMS FABRICATED FROM CERAMIC OR ELECTRICALLY RATED MATERIALS BY SPECIFICATION OR INDUSTRY STANDARDS USE INSULATOR (1), WASHER. EXCLUDES:DISK, VALVE, GRAPHITE IMPREGNATED AND LUBRICATED ITEMS.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 5310010205117 does not contain precious metals.
This information was last updated on Apr 01, 2024.