National Stock Number (NSN) 5330-01-105-2013, or NIIN 011052013, (ring,wiper) was assigned December 18, 1980 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There are 3 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is somewhat common among different platforms, belonging to 3 different weapons systems.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Dec 14, 2013, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 20256. [A CIRCULAR, SINGLE OR MULTIPIECE, RIGID, METALLIC OR NONMETALLIC ITEM HAVING A CENTRALLY LOCATED HOLE WITH A SHARP EDGE ON THE INSIDE PERIPHERY. IT IS SUPPLIED IN VARIOUS CROSS-SECTIONAL SHAPES AND IS DESIGNED TO BE INSTALLED IN A CYLINDER, SHOCK STRUT, OR SIMILAR DEVICE TO REMOVE EXCESS OIL, DIRT, ICE, AND/OR FOREIGN MATERIAL FROM A PISTON, RAM, OR SLIDING ROD. EXCLUDES:PACKING, PREFORMED; RING, PISTON; AND SEAL RING, METAL.]. This item does not have a nuclear hardened feature but does have other critical feature(s) such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5330011052013 does not contain precious metals.
This NSN is associated to Schedule B 8412909005: parts of linear acting hydraulic power engines and motors. The Schedule B End Use is listed as industrial engines. NAICS classification category 333995: fluid power cylinder and actuator manufacturing.
This information was last updated on Jul 01, 2025.