National Stock Number (NSN) 5330-01-241-6248, or NIIN 012416248, (ring,wiper) was assigned September 30, 1986 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN replaces 1 stock number, 5330001851388.
There are 3 manufacturer part numbers associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, 2 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, 2 suppliers are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over a year. There have been 4 contracts issued for this part number, with 4 awards given. There is minimal competition for this NSN. The US Government has awarded contracts to 3 different suppliers. The last contract numbers awarded were: SPE7L321V4038, SPE7L121P1617, SPE5EJ17V7462, SPM5M212MV026. The total value of the awarded contracts has been US$ 1,064.84.
This NSN is somewhat common among different platforms, belonging to 10 different weapons systems.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Dec 13, 2008, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 20256. [A CIRCULAR, SINGLE OR MULTIPIECE, RIGID, METALLIC OR NONMETALLIC ITEM HAVING A CENTRALLY LOCATED HOLE WITH A SHARP EDGE ON THE INSIDE PERIPHERY. IT IS SUPPLIED IN VARIOUS CROSS-SECTIONAL SHAPES AND IS DESIGNED TO BE INSTALLED IN A CYLINDER, SHOCK STRUT, OR SIMILAR DEVICE TO REMOVE EXCESS OIL, DIRT, ICE, AND/OR FOREIGN MATERIAL FROM A PISTON, RAM, OR SLIDING ROD. EXCLUDES:PACKING, PREFORMED; RING, PISTON; AND SEAL RING, METAL.]. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5330012416248 does not contain precious metals.
This NSN is associated to Schedule B 8412909005: parts of linear acting hydraulic power engines and motors. The Schedule B End Use is listed as industrial engines. NAICS classification category 333995: fluid power cylinder and actuator manufacturing.
This information was last updated on Jun 01, 2025.