National Stock Number (NSN) 5330-01-423-0689, or NIIN 014230689, (seal,nonmetallic strip) was assigned December 14, 1995 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 3 suppliers. Today, 3 suppliers are listed as Active suppliers for this NSN. Of the active suppliers, 3 suppliers are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over a year. There have been 6 contracts issued for this part number, with 6 awards given. There is minimal competition for this NSN. The US Government has awarded contracts to 4 different suppliers. The last contract numbers awarded were: SPE7L121P3270, SPE5EM19V2600, SPE5EM17V3200, SPE5EM16V4928, SPE5EM16V4928. The total value of the awarded contracts has been US$ 783.76.
This NSN is unique to one weapons system.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Apr 26, 2008, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 36874. [AN ITEM FABRICATED FROM NONMETALLIC MATERIAL DESIGNED TO BE USED WHERE THERE IS NO RELATIVE MOTION BETWEEN JOINED PARTS. ITEMS HAVING A SQUARE OR RECTANGULAR CROSS SECTION MUST BE A SINGLE PIECE WHOSE ENDS MAY HAVE BEEN SECURED TOGETHER TO FORM A SPECIFIC SHAPE. IT MAY BE FORMED TO A SPECIFIC SHAPE, EXCEPT ROUND, WITH OR WITHOUT JOINTS. IT MAY HAVE FABRIC, CORD OR METAL REINFORCEMENT. EXCEPT FOR MOLDED CORNERS, END CUTS, AND MOUNTING FACILITIES SUCH AS HOLES, SLOTS, PRESS-FIT BUTTONS, OR THE LIKE, THE ITEM MUST BE OF ONE CONTINUOUS CROSS SECTION. FOR STRAIGHT ITEMS WITH SQUARE END CUTS AND WITHOUT MOUNTING HOLES, SLOTS OR PRESS-FIT BUTTONS SEE RUBBER STRIP. FOR ITEMS WITH ROUND CROSS SECTIONS SEE SEAL, NONMETALLIC ROUND SECTION. EXCLUDES:GASKET AND PACKING, PREFORMED.]. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5330014230689 does not contain precious metals.
This NSN is associated to Schedule B 3926904500: gaskets,washers & other seals. The Schedule B End Use is listed as other industrial supplies. NAICS classification category 339991: gasket, packing, and sealing device manufacturing.
This information was last updated on Jun 01, 2025.