National Stock Number
5340-01-056-4879
National Stock Number (NSN) 5340-01-056-4879, or NIIN 010564879, (hinge,butt) was assigned February 23, 1978 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is very common among different weapons systems, belonging to 26 different platforms.
There has been very little demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Apr 26, 2008, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22894. [A HINGE USUALLY WITH RECTANGULARLY SHAPED LEAVES. THE DIMENSION PARALLEL TO THE HINGE PIN MUST BE GREATER THAN THE DIMENSION TRANSVERSE TO THE HINGE PIN. IT MAY HAVE A TENSION COIL SPRING AT ITS PIVOT(S) FOR CLOSING ACTION, AND MAY HAVE A THIRD MEMBER BETWEEN ITS PIVOT(S) TO PERMIT THE DOOR, OR THE LIKE, TO SWING IN AN ARC FROM EITHER SIDE.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5340010564879 does not contain precious metals.
This NSN is associated to Schedule B 8302104090: other hinges and parts thereof of base metal nesoi. The Schedule B End Use is listed as finished metal shapes. NAICS classification category 332510: hardware manufacturing.
This information was last updated on May 01, 2025.