National Stock Number
5340-01-059-3534
National Stock Number (NSN) 5340-01-059-3534, or NIIN 010593534, (hinge,butt) was assigned April 10, 1978 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
This NSN is somewhat common among different platforms, belonging to 2 different weapons systems.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Jun 02, 2005, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The Government physically does not have in its possession sufficient, accurate, or legible data to purchase this part from other than current source(s). (NOTE: This code is applicable only to parts under immediate buy requirements and only as long as the deficiency is under review for resolution and appropriate recoding.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22894. [A HINGE USUALLY WITH RECTANGULARLY SHAPED LEAVES. THE DIMENSION PARALLEL TO THE HINGE PIN MUST BE GREATER THAN THE DIMENSION TRANSVERSE TO THE HINGE PIN. IT MAY HAVE A TENSION COIL SPRING AT ITS PIVOT(S) FOR CLOSING ACTION, AND MAY HAVE A THIRD MEMBER BETWEEN ITS PIVOT(S) TO PERMIT THE DOOR, OR THE LIKE, TO SWING IN AN ARC FROM EITHER SIDE.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5340010593534 does not contain precious metals.
This information was last updated on Jul 01, 2025.