National Stock Number
5340-01-580-4118
National Stock Number (NSN) 5340-01-580-4118, or NIIN 015804118, (hinge,butt) was assigned December 14, 2009 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years, with the most recent procurement date of Jan 03, 2019. There have been 4 contracts issued for this part number, with 4 awards given. There is minimal competition for this NSN. The US Government has awarded contracts to 2 different suppliers. The last contract numbers awarded were: SPE5EK19V1889, SPE5EK18V4651, SPE5EK15M0042, SPE5EK14V5781. The total value of the awarded contracts has been US$ 10,452.87.
This NSN is somewhat common among different platforms, belonging to 3 different weapons systems.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Apr 17, 2013, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. This part requires engineering source approval by the design control activity in order to maintain the quality of the part. An alternate source must qualify in accordance with the design control activity's procedures, as approved by the cognizant Government engineering activity. Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 22894. [A HINGE USUALLY WITH RECTANGULARLY SHAPED LEAVES. THE DIMENSION PARALLEL TO THE HINGE PIN MUST BE GREATER THAN THE DIMENSION TRANSVERSE TO THE HINGE PIN. IT MAY HAVE A TENSION COIL SPRING AT ITS PIVOT(S) FOR CLOSING ACTION, AND MAY HAVE A THIRD MEMBER BETWEEN ITS PIVOT(S) TO PERMIT THE DOOR, OR THE LIKE, TO SWING IN AN ARC FROM EITHER SIDE.]. This item does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5340015804118 does not contain precious metals.
This information was last updated on Aug 01, 2025.