National Stock Number
5365-00-116-5673
National Stock Number (NSN) 5365-00-116-5673, or NIIN 001165673, (shim) was assigned September 30, 1968 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There are 2 manufacturer part numbers associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on May 02, 2005, this NSN's acquisition method was noted as: Acquire only from the prime contractor although the engineering data identifies the Commercial and Government Entity Code (CAGE) and part number of a source other than the prime contractor. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 20349. [A THIN FLAT METAL OR PLASTIC ITEM OF VARIOUS PERIPHERAL SHAPES HAVING A SOLID OR LAMINATED CROSS-SECTION. IT IS DESIGNED TO MAINTAIN A PREDETERMINED DISTANCE BETWEEN TWO SURFACES. FOR ROUND ITEMS WITHOUT A HOLE AND HAVING A SOLID RECTANGULAR CROSS-SECTION USE DISK, SOLID, PLAIN. ITEMS WITH EITHER (1) A SOLID (NOT LAMINATED) CROSS-SECTION, OR (2) A NON-SEPARABLE LAMINATED CROSS-SECTION WITH ONE HOLE CENTRALLY LOCATED, MUST HAVE A THICKNESS LESS THAN 0.006 INCH (0.152 MM) FOR ITEMS LESS THAN 1/4 INCH (6.35 MM) OUTSIDE DIAMETER OR SHORTEST DISTANCE ACROSS PERIPHERAL FLATS, AND LESS THAN 0.016 INCH (0.406 MM) FOR ITEMS 1/4 INCH (6.35 MM) OR MORE OUTSIDE DIAMETER, OR SHORTEST DISTANCE ACROSS PERIPHERAL FLATS. FOR ITEMS WITH THICKNESS GREATER THAN THOSE INDICATED ABOVE, SEE SPACER, PLATE; WASHER, FLAT AND SPACER, RING. WHEN THICKNESS AND/OR OUTSIDE DIAMETER OR SHORTEST DISTANCE ACROSS PERIPHERAL FLATS IS DESIGNATED AS A TOLERANCE DIMENSION, THE MAXIMUM DIMENSION WILL BE USED TO DETERMINE COMPLIANCE. SEE ALSO SHIM STOCK, LAMINATED; SHIM STOCK ASSORTMENT, GASKET; AND BEARING, WASHER, THRUST.]. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 5365001165673 does not contain precious metals.
This information was last updated on May 01, 2024.