National Stock Number
5365-01-246-6882
National Stock Number (NSN) 5365-01-246-6882, or NIIN 012466882, (spacer,plate) was assigned December 18, 1986 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. None of the associated part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by one supplier. Today, there are no suppliers listed as an Active supplier for this NSN. Of the active suppliers, there are no suppliers that are deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over 5 years.
Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Jul 02, 2006, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The Government physically does not have in its possession sufficient, accurate, or legible data to purchase this part from other than current source(s). (NOTE: This code is applicable only to parts under immediate buy requirements and only as long as the deficiency is under review for resolution and appropriate recoding.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 26979. [A FLAT METAL OR PLASTIC ITEM OF VARIOUS PERIPHERAL SHAPES HAVING A SOLID (NOT LAMINATED) CROSS-SECTION. IT IS DESIGNED TO MAINTAIN A PREDETERMINED DISTANCE BETWEEN TWO SURFACES. FOR ROUND ITEMS WITHOUT A HOLE HAVING A SOLID RECTANGULAR CROSS-SECTION USE DISK, SOLID, PLAIN. FOR ROUND OR HEXAGONAL ITEMS WITH ONLY ONE HOLE CENTRALLY LOCATED AND WITH THE LENGTH (THICKNESS) EXCEEDING 25 PERCENT OF THE OUTSIDE DIAMETER OR DISTANCE ACROSS PERIPHERAL FLATS, SEE SPACER, SLEEVE. THE THICKNESS BETWEEN THE TWO PARALLEL BEARING SURFACES MUST BE 0.006 INCH, (0.152 MM) OR MORE FOR ITEMS LESS THAN 1/4 INCH (6.35 MM) ACROSS THE PERIPHERAL DIAMETER, OR SMALLEST OVERALL OUTSIDE DIMENSION, OR MUST BE 0.016 INCH (0.406 MM) OR MORE FOR ITEMS 1/4 INCH (6.35 MM) OR GREATER ACROSS THE PERIPHERAL DIAMETER OR SMALLEST OVERALL OUTSIDE DIMENSION. FOR ITEMS WITH A THICKNESS LESS THAN THOSE INDICATED ABOVE, SEE SHIM. FOR ITEMS WITH ONE HOLE CENTRALLY LOCATED CONFORMING TO THE ABOVE DIMENSIONAL CRITERIA USE WASHER, FLAT OR SPACER, RING AS APPLICABLE. WHEN THICKNESS AND/OR OUTSIDE_DIAMETER_OR_SMALLEST_OVERALL_OUTSIDE_DIMENSION_IS_DESIGNATED_AS_A_TOLERANCE/DIMENSION_THE_MAXIMUM_DIMENSION_WILL_BE_USED_TO_DETERMINE_COMPLIANCE._EXCLUDES:GASKET;_INSULATOR_(AS_MODIFIED)_AND_MOUNTING_PAD,_ELECTRICAL-ELECTRONIC_COMPONENT.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________]. There is no data in the HMIRS and the NSN is in an FSC not generally suspected of containing hazardous materials. NSN 5365012466882 does not contain precious metals.
This information was last updated on Jul 01, 2025.