National Stock Number (NSN) 5970-01-253-5134, or NIIN 012535134, (insulator,washer) was assigned April 19, 1987 in the Federal Logistics Information System (FLIS). This NIIN is Available for Manual Assignment. This NSN does not replace any other NSNs.
There is only one manufacturer part number associated with this NSN. One of those part number(s) are considered obsolete. The manufacturer part numbers were originally supplied by 2 suppliers. Today, one supplier is listed as an Active supplier for this NSN. Of the active suppliers, only one supplier is deemed design controlled or valid supply parts.
This part number has not been procured by the US Government in over a year. There have been 8 contracts issued for this part number, with 8 awards given. There is moderate competition for this NSN. The US Government has awarded contracts to 7 different suppliers. The last contract numbers awarded were: SPE4A624PL901, SPE4A622PD265, SPE4A622P8766, SPE4A620PK324, SPE4A619PA824. The total value of the awarded contracts has been US$ 5,578.14.
This NSN is somewhat common among different platforms, belonging to 4 different weapons systems.
There has been a small amount of demand for this national stock number. The demand for this NSN originated from less than 5 countries. Based on a planned procurement review by the Primary Inventory Control Activity (PICA) on Dec 21, 2013, this NSN's acquisition method was noted as: Acquire directly from the actual manufacturer, whether or not the prime contractor is the actual manufacturer. The annual buy value of this part falls below the screening threshold of $10,000 but it has been screened for known source(s). (NOTE: This code shall not be used when screening parts entering the inventory. It shall not be assigned in preference to or supersede any other AMSC.) Valid AMCs: 1, 2, 3, 4 and 5.
This NSN is assigned to Item Name Code (INC) 18294. [AN INSULATOR THAT IS ESSENTIALLY THIN AND FLAT, WITH ONE THROUGH HOLE CENTRALLY LOCATED. THE GENERAL SHAPE MAY VARY BY THE ADDITION OF FEATURES SUCH AS BEVELED EDGES, INDENTED SURFACES, THROUGH HOLE KEYS, AND/OR PERIPHERAL FLATS. THE THICKNESS MEASURED BETWEEN THE TWO PARALLEL BEARING SURFACES MUST NOT EXCEED 25 PERCENT OF THE OUTSIDE DIAMETER OR THE SHORTEST DISTANCE BETWEEN PERIPHERAL FLATS. THE THICKNESS MEASURED BETWEEN THE TWO PARALLEL BEARING SURFACES MUST NOT EXCEED 25 PERCENT OF THE OUTSIDE DIAMETER OR THE SHORTEST DISTANCE BETWEEN PERIPHERAL FLATS. EXCLUDES:ITEMS WITH MORE THAN ONE HOLE. SEE ALSO INSULATOR, DISK; INSULATOR, BEAD; INSULATOR, BUSHING; AND INSULATOR, PLATE]. There is no information in the HMIRS; however, the NSN is in an FSC in Table II of Federal Standard 313 and an MSDS may be required by the user. The requirement for an MSDS is dependent on a hazard determination of the supplier or the intended end use of the product. NSN 5970012535134 does not contain precious metals.
This NSN is associated to Schedule B 8546900000: electrical insulators, nesoi. The Schedule B End Use is listed as electric apparatus. NAICS classification category 326199: all other plastics product manufacturing.
This information was last updated on Jul 01, 2025.